I am stamping honest........

But I can't share !  Sorry.

I've been working on some commissions for magazine articles so they have to stay under wraps, I've been putting the final touches to my classes for the autumn and my hostess event at the end of September, none of which I can share with you, yet !

I can however share this little bit of a card...............it's for a very special lady but it's not her birthday until the 31st so I won't spoil the surprise but pop back and you will see it on Sunday.

I promise to have some more cards for you very soon.

Penny Spinner Instructions

Penny Spinner Cards

Craft knife and metal ruler
Image to spin
3D Stampin' Dimensionals
2 x 1p coins
Cardstock, paper and embellishments

1. Take your folded card and layer a piece of patterned paper ¼” or 0.5cm smaller onto the front.
2. Cut a piece of strong cardstock for the spinner holder, the size will be determined by how much of the backing paper you wish to see, between ½” or 1cm and 1 ½” or 3cm is about right.
3. Working on the reverse side of the spinner holder find the centre point of the card and draw a cross going to each edge of the card.
4. From the centre point mark a line 0.7cm above and below, stop the line 2cm in from the edge (you can vary this dependant on the size of the item that will spin.)
5. Using a metal ruler and craft knife cut this rectangle out. It is much better to cut inside the line and trim off rather than cut too big in the first place !
6. Sandwich a foam circle in between 2 pennies and attach the item to spin onto the top of one of the pennies, slot into the cut section of the card with a penny on either side. Check to see if it spins. If it gets stuck then trim a little excess off the card. Sometimes it takes a few goes for it to get started.
7. When you are happy it works attach the spinner holder card to your card front using foam pads or tape, make sure you use plenty so the pennies can move freely. Decorate the card further if you wish.

Top Tip

If you make a template for a A5, Square and DL card following the steps 4 – 7 using pieces of scrap card, you can just trace out the image on the back and cut out without having to measure every time!

Variations

Diagonal spinner – Find the centre point from each diagonal corner, mark the slot as before working on the diagonal lines.

Wobbly line – Use a free hand blade to cut the top line on a scrap piece of card and draw a pencil line along it. Then move the scrap piece of card approximately 1.4 cm down and mark a second line and cut out as before.

Penny Spinner card

I love cards that move and this style of card looks so effective but is really easy to make.

To make this card I have used

Certainly Celery card, ink and Designer series paper

Pick a petal stamp set

Simply said stamp set for the greeting in the spinner runner

Stampin' Dimensionals

2 pennies

I will post a series on instructions in a day or 2.